What makes these light bars cheap? Parts used to produce these lights and its manufacturing process. Parts required to produce these Cheap lights are reasonably low-priced and its manufacturing process is very easy. All you need is solder LEDs and strip wires and should know how to operate a power drill to produce Cheap light bars, adding a warm glow to your home. Once you have gathered all the required parts, it will hardly take 3 to 4 hours to put together all the parts to bring it in the form of a light bar.

Though, the parts required to produce a Cheap light bar are many but the cost of these parts are very low and easy-to-use. You can find most if these parts at your home. Therefore, don’t be shocked by knowing the amount of parts needed.

Some of the parts required are mentioned as follows:

· Light bar Metal Wire Cover: This low cost light bar metal wire cover is readily available in the market and can help you in developing a Cheap light bar. You can modify your own light bar according to your requirement.

· Rubber Insulated Clamps: These less expensive rubber insulated clamps are used to fix your Cheap light bar to a surface.

· Electrical Tape: Electric tape is required to hold all the pieces together and protect wires coming from the bar.

· Wet Rag : You can use any kind of sponge or cloth, all you need to do is soak it in the water and then clean the leftover solder off the soldering iron.

· LEDs: In LEDs you can select any color of your choice and adjust the brightness according to your requirements.

· Hot Glue Gun: More than one glue sticks might be needed because its not that easy to hold all the parts in place.

· Power Supply: Any source of power can be used though it is preferable that you run LEDs on DC.

· Resistors: It helps keeps the LED consume additional electricity. It has the capacity to change a 12 volt power supply into a 3.3 volt power supply.

· Gauge Speaker Wire: These wires are also not very expensive and are used to connect the LEDs with the power supply.

· Soldering Iron: Soldering iron, one of the Cheap light bar part that everyone should have.

· Needle-nose Pliers: This equipment is required to bend LED legs.

Few of the other parts required to form a Cheap light bar include, a power drill which can also be borrowed, wire clippers or small scissor used to cut the legs of LEDs, awl or anything sharp having a fine point and last but not the least a knife or a wire stripper to strip out plastic insulation from the wire. Making a Cheap light bar is not at all a difficult task, all it requires is a little of your time and hard work.

Extreme Tactical Dynamics is a one-stop shop for Cheap light and many other items like Flashlights, Dash Lights, Deck Lights, etc. Please visit the site for more details of various items available - http://www.extremetacticaldynamics.com/